Use the following procedure to troubleshoot the air conditioning system.
*: Use the GTS.
| Proceed to |
|---|
| NEXT |
NEXT
Inspect the battery voltage with the ignition switch off.
11 to 14 V
If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.
| Proceed to |
|---|
| NEXT |
NEXT
Use the GTS to check if the LIN communication system is functioning normally.
| Proceed to |
|---|
| LIN DTC is not output |
| LIN DTC is output |
LIN DTC is not output
LIN DTC is output
Use the GTS to check if the CAN communication system is functioning normally.
| Proceed to |
|---|
| CAN DTC is not output |
| CAN DTC is output |
CAN DTC is not output
CAN DTC is output
for LHD:
for RHD:
Check for DTCs and note any codes that are output.
Clear the DTCs.
Recheck for DTCs. Based on the DTCs output above, try to force output of the air conditioning system DTC by simulating the operation indicated by the DTC.
| Proceed to |
|---|
| DTC is not output |
| DTC is output |
DTC is not output
DTC is output
| Proceed to |
|---|
| Fault is not listed in Problem Symptoms Table |
| Fault is listed in Problem Symptoms Table |
Fault is not listed in Problem Symptoms Table
Fault is listed in Problem Symptoms Table
Panel diagnosis (indicator check, sensor check)
On-vehicle Inspection
Inspection
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT